◆Small size, light weight, easy to install
◆Low loss, low heat, low temperature rise
◆Excellent self-healing performance
◆Safety
◆Dry structure does not leak oil, safe and environmentally friendly

1. Use a one-time stretched aluminum shell package;
2. The impregnant is pollution-free;
3. Built-in overvoltage device and discharge resistance;
4. Capacitor components are made of high-quality high-temperature metalized polypropylene film;

Rated voltage: 230V, 400V, 450V, 480V, 525V, 690V, 750V, 1200V, other voltages can be specially ordered.
Rated capacity: 0.4-0.69kv and 1-60kvar, the capacity of other voltage levels will be determined separately.
Rated frequency: 50Hz or 60Hz0
capacity tolerance: -5%-+10%.
Loss angle tangent: tanδ ≤ 0.1% at 20°C.

1. Three single-phase capacitors are connected to Y-neutral point (marked with N terminal) to form three single-phase common body capacitors. When in use, each of AN, BN, and CN is an independent unit.
2. Each independent unit is connected with a discharge resistor, which is safer to use.
3. The damage of any independent unit has been connected with a pressure isolating device and can be reliably disconnected.

1. Rated voltage level (kV): 0.33, 0.45, 0.48, 0.525, 0.82
2. Rated capacity (kvar): 15-100
3. Capacitance deviation (μF): 0一＋3%
4. Loss angle tangent (tanδ) :≦0.1 %(Un5OHz2O℃)

1. Large capacity: 300-5000μF
2. Large current: the maximum current reaches 2500A
3. High voltage: 800-1800VDC
4. Cooling method: full water cooling or semi-water cooling

1. The altitude does not exceed 1000m, the ambient temperature is 40/B, and the maximum temperature of type B is +45℃.
2. There is no severe mechanical vibration, no harmful gas and steam, no conductive or explosive dust in the installation place.
3. The capacitor should be operated under well-ventilated conditions, and it is not allowed to operate under airtight and unventilated conditions.
4. The wiring of the capacitor should use soft wires, and the entire loop should be in good contact.

1. Altitude: <2000m
2. Ambient temperature: 5℃-45℃
3. Ambient humidity: ≦85%
4. Capacity deviation: ±5%

1. Altitude environment: ≦2000m
2. Ambient temperature: -25-40°C
3. Ambient humidity: ≦85%
4. Protection level: IP00 for indoor installation

LMZ (J) 1-0.5 type current transformer is mainly used for indoor AC circuit with rated voltage of 0.5kV and below and rated frequency of 50Hz as current and electric energy measurement or relay protection. The product adopts casting insulation and fixed installation with installation base plate.

LMZ (J) 1-0.66 type current transformer is mainly used for indoor AC circuit with rated voltage of 0.66 kV and below and rated frequency of 50 Hz as current and electric energy measurement or relay protection. The product adopts pouring insulation and fixed installation method of bus bar.

Lmk1 (BH) 1-0.66 type current transformer is mainly used for indoor AC circuit with rated voltage of 0.66 kV and below and rated frequency of 50 Hz as current, electric energy measurement or relay protection function. The product adopts cast insulation and is widely used in complete sets of cabinets. Its installation method can adopt bus fixed and bottom fixed installation method, which is suitable for installation in any direction, The primary conductor can be busbar or cable.